How to Disassemble Vita Game Cartridges

A hacker named katsu recently released a method for dumping Vita games. As a developer, I am completely against piracy, but as a reverse engineer I can’t shy away from taking apart perfectly working devices. However, most pictures I see of Vita game carts taken apart show the game cart casing damaged beyond repair or completely destroyed. I managed to take apart a game cart and put it together with no obvious signs of damage, and I thought I would share my (simple) method here. Continue reading

Dumping the Vita NAND

When we last left off, I had spent an excess of 100 hours (I’m not exaggerating since that entire time I was working, I listened to This American Life and went through over a hundred one-hour episodes) soldering and tinkering with the Vita logic board to try to dump the eMMC. I said I was going to buy a eMMC socket from taobao (the socket would have let me clamp a eMMC chip down while pins stick out, allowing the pressure to create a connection) however, I found out that all the sellers of the eMMC socket from taobao don’t ship to the USA and American retailers sell the sockets for $300 (cheapest I could find). So I took another approach. Continue reading

PS Vita NAND Pinout

Vita NAND Pinout

As promised, here’s the pinout for the Vita’s eMMC (NAND). Don’t be fooled by the picture; the size of the resistors are TINY. Plus, if you noticed, half the traces are almost hugging the shield base (which is pretty hard to remove without disturbing the resistors). I hope I can find a better way to dump the eMMC than soldering to these points. It’s doubtful that they are exposed elsewhere as I’ve checked every unfilled pad on both sides of the board. Wish me luck…

To get an idea of where these resistors are located, check the iFixit picture for reference (black box is where they are).

To get an idea of where these resistors are located, check the iFixit picture for reference (black box is where they are).

Comparsion

To get an idea of the size of the resistors, I’ve placed a 0.7mm pencil lead next to them.

 

Removing the CPU and NAND from PSVita

Thanks again to everyone who helped fund this project! This is the first part of the long journey into hardware land. I bought a non-working Vita logic board from eBay, which arrived yesterday, packaged like a freeze-dried snack.

As delicious as it looks.

As delicious as it looks.

In order to locate the trace from the eMMC (aka the NAND), my plan was to take a broken logic board and remove the eMMC chip and use the exposed pads and trace it to a test point or something. Then take another Vita logic board (this time with the eMMC still attached) and solder wires to the test point and dump it with an SD card reader or something (as eMMC uses the same interface as SD cards). This is a complicated plan, but it’s necessary because I am not professional enough to be able to remount the eMMC (which is a tiny fine-ball-grid-array (FBGA) chip) once the trace is found. Continue reading